Simple stool/ sidetable

 Cut the legs

Bowl collaboration

Here are some photos from my bowl made from Mahogany. There was a an error in the video which these photos weren't shown. 

EDIT(28/07/2015 19:26 GMT the photos are infact included)

Electrical solder wall storage

 I am starting this project with a pine varnished pine tongue and groove floor board and iI preceded to mark to lines 4"/100mm apart.

 I then clamped a simple circular saw guide lining up the mark.

 after it was cut I then took as hand plane in my case I used a Stanley #5 but a #4 would work fine its just a little easer with the longer body of the #5 .

Homemade Captive Ring Tool

Make your own captive rings on a lathe using homemade tools from an old screwdriver!

 drilling hole through screw driver

Indestructable memory stick v2.0 - build + test

I am going to start writing on here more now and I will write about my videos and also things that might not make it to youtube







I had good fun torture testing this beast and it survived high temperatures of a torch, 45 min dunk in water, run over by a car several times and hit with a sledge hammer really hard, and it still works !

The usb enclosure is constructed using 18mm plywood (3/4") in three layeres in the middle one I drilled and cut a slot for the usb.that is held to gether using four lag bolts.

I then hammered some food cans to the plywood then I held it securley, I used some washerhead screws to secure it.

v1 here https://www.youtube.com/watch?v=YryPeDBoQ18

v2 here https://www.youtube.com/watch?v=GP6zAvN991w

subscribe to my youtube channel here for a new video just about everyweek

Wall Planter 2.0

so i had previously made a planter it used a french cleat whilst that was practilal over time it would sag from the weight so i decided that screws would be better(but a cleat could still be used) so I made another one also constructed

i have free plans avalable to download here free plans

3D print show 2014 LONDON